120 • Using Setup Mode
EAGLE 2 Operator’s Manual
Exiting Setup Mode
1. From the main menu, place the cursor in front of
NORMAL OPERATION
at the
bottom of the menu.
2. Press and release POWER ENTER RESET.
3. A screen appears that asks if you want to save the changes you have made.
NOTE:
If you entered Setup Mode and did not make any changes, the above screen will
still appear. In this case, press and release DISPLAY ADJUST NO to proceed
to exit Setup Mode and begin the EAGLE 2’s startup sequence.
4. If you do not want to save the changes, press and release DISPLAY ADJUST NO.
The unit will begin its startup sequence without saving the changes.
If you do want to save the changes, press and release AIR
▲
YES and continue with
the next step.
5. A confirmation screen appears asking if you are sure you want to save the changes.
6. If you want to save the changes, press and release AIR
▲
YES to save the changes. A
screen will appear for a few seconds indicating that the changes have been saved and
the unit will begin its start-up sequence.
If you do not want to save the changes, press and release DISPLAY ADJUST NO to
proceed to the unit’s start-up sequence without saving changes.
SAVE ALL CHANGES
IN MEMORY?
ARE YOU SURE YOU
WANT TO SAVE ALL
CHANGES IN MEMORY?
www.
.com
information@itm.com
1.800.561.8187
