250 • Start Up, Leak Check Mode
EAGLE 2 Operator’s Manual
5. The Battery Voltage Screen appears for a few seconds.
6.
The Mode Select Screen displays.
7.
The cursor will flash in front of NORMAL MODE. Use the
RANGE
▼
SHIFT
button to move the cursor next to
LEAK CHECK MODE
.
8. With Leak Check Mode selected, press and release the POWER ENTER RESET
button to begin the Leak Check Mode startup sequence.
NOTE:
If no button is pressed for 20 seconds, the unit will proceed into whichever
mode has the cursor in front of it.
9. The Active Gases Screen appears for a few seconds indicating which channels are
active and their target gas.
BATTERY MIN:
4.3 VOLTS
BATTERY NOW:
5.2 VOLTS
> NORMAL MODE
BAR HOLE MODE
LEAK CHECK MODE
ACTIVE GASES
CH4 OXY
H2S CO
CH4
www.
.com
information@itm.com
1.800.561.8187