32 • Using the Battery Charger for Continuous Operation EAGLE 2 Operator’s Man
-
Turning Off the EAGLE 2
1. Press and hold the POWER ENTER RESET button.
2. The buzzer will pulse for about five seconds.
3. Release the button when GOODBYE and the RKI logo appear on the display. When
GOODBYE and the RKI logo disappear and the backlight turns off, the unit is off.
Using the Battery Charger for
Continuous Operation
The battery charger can be used with an AC adapter or a vehicle plug DC adapter to run
the EAGLE 2 in continuous operation instead of charging the batteries. Batteries do not
need to be installed in the EAGLE 2 but if there are batteries installed, they must be NiMH
batteries and they must have a charge.
WARNING:
Use the EAGLE 2 charger’s continuous operation mode to power the
EAGLE 2 only if NiMH batteries are installed in the EAGLE 2 or if no
batteries are installed in the EAGLE 2. Do not use the charger for
continuous operation if alkaline batteries are installed.
1. Place the EAGLE 2 in the area to be monitored.
2. Plug the power adapter into either an AC outlet or into a vehicle outlet depending on
which charger is being used.
3. Set the switch on the module to “CONT. OPERAT.”.
4. Make sure the EAGLE 2 is off.
5. Make sure the adapter and module are connected.
6. Make sure that the NiMH batteries are either charged or removed.
NOTE:
If the batteries are not charged, the EAGLE 2 will not turn on and will instead
give a “Charge Batteries” indication when it is powered up after Step 7 below.
7. Insert the module’s round plug into the EAGLE 2’s charging jack as shown in Figure
Figure 17: Connecting the EAGLE 2 to the Charger
www.
.com
information@itm.com
1.800.561.8187