EAGLE 2 Operator’s Manual
Display Mode • 49
To select a different user ID:
1. With the Select User ID Screen displayed, press and release the AIR
▲
YES button.
A screen appears that includes the current user ID which is indicated by the cursor
next to it.
The user IDs are displayed in groups of six. The previous group of six is displayed
when the cursor is moved up past the top of the LCD. The next group of six is
displayed when the cursor is moved down past the bottom of the LCD. The list will
not “wrap around” to the previous screen if the cursor is moved up from the first user
ID or to the next screen if the cursor is moved down from the last user ID. Any of the
user IDs in the list that have not been changed from the factory setting will be shown
as dashes (-).
2. Use the AIR
▲
YES and RANGE
▼
SHIFT buttons to move the cursor up and down
the screen and scroll through the available user IDs to find the desired user ID.
3. When the desired user ID is displayed, place the cursor next to it, press and release the
POWER ENTER RESET button.
NOTE:
To exit the selection screen without saving a change, press and release the
DISPLAY ADJUST NO button. You will return to the Select User ID screen
without saving the user ID change.
4. The unit will save the selected user ID as the current one and proceed to the Select
Station ID Screen.
Select Station ID Screen
This screen displays only if USER/STATION ID in the Setup Mode menu is set to ON (see
“Turning the User/Station ID Function On or Off” on page 109). Use this screen to select a
station ID from the station ID list in the EAGLE 2’s memory. The current station ID is
displayed. A station ID can be up to 16 characters long. The EAGLE 2 can store up to 128
station IDs.
The station ID provides a way to identify a location where monitoring was done during a
data logging session. If the station ID is changed during an operating session, a new data
session is initiated with the new station ID attached to it. This allows you to change the
station ID during operation and have each station ID that was used during an operating
session saved for the corresponding data. See the Eagle 2 Data Logger Management
Program Operator’s Manual for a detailed description of data logging and the station ID.
Bruce
> John
Mike
----------------
----------------
----------------
SELECT
STATION ID?
CURRENT STATION
Pump 2
www.
.com
information@itm.com
1.800.561.8187
