EAGLE 2 Operator’s Manual
Replacing or Recharging the Batteries • 69
Replacing or Recharging the Batteries
WARNING:
To prevent ignition of a hazardous atmosphere, batteries must only be
changed or charged in an area known to be nonhazardous.
Replace or charge the batteries when the EAGLE 2 indicates that it is in low battery
warning. When in low battery warning, BATT appears vertically along the left side the
LCD.
Replacing the Batteries
NOTE:
Use Duracell Procell PC 1400 alkaline batteries, Duracell MN 1400 alkaline
batteries, Energizer E93 or Energizer EN93, or RKI Instruments, Inc. 4
9-1330RK Ni-MH batteries to maintain the CSA classification of the EAGLE
2. Use of other batteries or mixing alkaline and rechargeable batteries will void
the CSA classification and may void the warranty.
1. Turn off the EAGLE 2.
WARNING:
Do not remove the batteries while the EAGLE 2 is on.
2. Loosen the battery case thumbscrew by turning it counterclockwise until it
disengages from the bottom case. If necessary, use a coin or large flat blade
screwdriver to loosen it.
Figure 18: Removing the Battery Case
3. Pull the battery case away from the bottom case. The thumbscrew is captive and will
not fall out.
4. Carefully remove the old batteries. Verify that the battery compartment and electrical
contacts are clean.
CH4 0%LEL
B OXY 20.9vol%
A H2S 0.0ppm
T CO 0ppm
T
www.
.com
information@itm.com
1.800.561.8187