70 • Replacing or Recharging the Batteries
EAGLE 2 Operator’s Manual
5. Carefully install the new C-size batteries. Follow the battery diagram inside the
battery case. Make sure the batteries are pushed in all the way.
Figure 19: Installing the Batteries
6. Reinstall the battery case onto the bottom case tightening the thumbscrew firmly by
hand so that there is no visible gap between the battery case and the bottom case.
Recharging the Ni-MH Batteries
CAUTION:
Use with Ni-MH battery p/n 49-1330RK. Charge only with RKI charger
model 49-2175RK, 49-2176RK, or 49-2177RK. Use of other rechargeable
batteries or chargers or charging of other rechargeable batteries in the
EAGLE 2 will void the warranty.
WARNING:
Do not plug the charger cable into a battery pack that contains alkaline
batteries. Do not attempt to charge alkaline batteries.
The charging module can either be used with an AC adapter or a vehicle plug DC adapter.
Both adapters plug into the module which then plugs into the EAGLE 2.
1. Plug the power adapter into either an AC outlet or into a vehicle outlet depending on
which charger is being used.
2. Make sure the switch on the module is set to “BATT. CHARGER”.
3. Make sure the EAGLE 2 is off.
4. Make sure the adapter and module are connected.
www.
.com
information@itm.com
1.800.561.8187
