EAGLE 2 Operator’s Manual
General Parts List • 79
14. Confirm that the main PCB is seated in its slots and that its bottom edge is resting on
the bottom of the bottom case. If the main PCB is not seated properly, then it may be
damaged when the top case is re-installed.
15. Make sure that the top case gasket is fully seated in its groove and carefully put the
top case back on the bottom case. If you have any difficulty mating the top and
bottom cases, inspect the placement of the main PCB and the placement of the top
case gasket.
16. Turn the EAGLE 2 upside down and tighten the three case screws to secure the top
case to the bottom case.
17. Calibrate the new sensors as described in “Chapter 4: Calibration Mode” on page 54.
General Parts List
Table 11 lists part numbers for the EAGLE 2’s replacement parts and accessories.
Table 11: General Parts List
Part Number
Description
06-1248RK-03
Calibration kit tubing,3 foot length
07-7210RK
O-ring for inlet fitting half of probe
07-7304RK
O-ring for tube half of probe
13-1061RK
Panel screw, captive, 6-32 x 1/2 inch, for bottom case
13-1081RK
Thumbscrew, captive, 10-32 x 2 inches, for battery case
30-0600RK-01
Pump
33-0156RK-01
Filter element, hydrophobic disk, for standard 80-0131RK-10 probe,
pack of 5
33-0173RK
Internal hydrophobic filter
33-1200RK
Particle filter for standard 80-0131RK-10 probe
33-2002RK-01
Humidifier, 24 inch, for calibration of catalytic combustible channel
with gas concentrations of 1000 ppm or lower
33-6090RK
Charcoal filter
35-0110RK
Dummy sensor, CO or H
2
S sensor position
35-0111RK
Dummy sensor, oxygen sensor position
35-0112RK
Dummy sensor, LEL sensor position
47-1016RK
Vehicle plug 12 VDC adapter cable for charger
47-5010RK
TC/LEL sensor cable
47-5084RK
USB/IrDA adapter module, Legasic, for use with all premier
portables (without USB cable)
www.
.com
information@itm.com
1.800.561.8187
