96 • Tips for Using Setup Mode
EAGLE 2 Operator’s Manual
The EAGLE 2 is factory-set to suit most applications. Update settings in Setup Mode only
if required for your specific application. The description of each item below indicates the
factory setting for each item.
Tips for Using Setup Mode
•
When in the main menu, the cursor (>) flashes in front of a menu item indicating that
the item is selected.
•
Use the RANGE
▼
SHIFT button to move the cursor down through the main menu
and submenu items, and to lower values or change the setting in a specific option.
•
Use the AIR
▲
YES button to move the cursor up through the main menu and
submenu items, and to raise values or change the setting in a specific option.
•
A down arrow in the lower right corner or an up arrow in the upper right corner of the
LCD indicates that additional menu items can be viewed by pressing and releasing the
RANGE
▼
SHIFT button in the case of the down arrow or the AIR
▲
YES button in
the case of the up arrow. The example below illustrates a down arrow in the lower
right corner.
•
Use the POWER ENTER RESET button to enter a selected menu item with the cursor
next to it and to enter and save settings during programming.
•
An adjustable parameter that is flashing can be adjusted with the AIR
▲
YES and
RANGE
▼
SHIFT buttons.
•
Press the DISPLAY ADJUST NO button while in a screen where you are entering or
updating parameters to exit the screen without saving any changes.
Using Setup Mode
WARNING:
The EAGLE 2 is not in operation as a gas detector while in Setup Mode.
1. Take the EAGLE 2 to a non-hazardous location and turn it off if it is on.
2. Press and hold the AIR
▲
YES and RANGE
▼
SHIFT buttons, then press and hold
the POWER ENTER RESET button. When you hear a beep, release the buttons.
>SET DATE & TIME
SET DATE FORMAT
SET BATTERY TYPE
CONFIGURE CHANNELS
CONFIGURE GASES
CATALYTIC UNITS
www.
.com
information@itm.com
1.800.561.8187
