30 • Chapter 4: Program Setup
expiration date and will not include the associated inlet in testing.
If the
Active
box is deselected, the program will not consider it a cylinder being used and will
give you an inlet error if you connect an instrument that requires that cylinder for bump testing
or calibration.
7.
Make any other changes to other cylinders.
8.
Click
OK
and then click
Yes
in the window that comes up to return to the Main Window.
Defining PC Program Operation
The Configuration Window allows you to update parameters that only affect PC Program operation,
view database information, and change the password to enter the Configuration Window.
Parameter Tab
The Parameter Tab allows you to view or change bump test and calibration settings that only apply to
the PC Program operation. Changing anything in the Parameter Tab of the Config Window does not
change any settings in the SDM-3R and, therefore, does not affect Standalone Mode operation.
1.
While in the main program window, click the
Config
button.
2.
Enter the password and click
OK
. The default password is
ABCDE
(case sensitive).
3.
The
Parameter
tab is displayed.
Figure 18: Config Window Parameter Tab
4.
Change parameters, as necessary.
