Quick Start Guide:
A more complete guide to the installation is featured later
1. Connect the RTX input connector to transceiver
with 50 Ohm patch cable
2. Connect the ANT Output of the Amplifier to SWR
Bridge / Wattmeter (If required), and then the An-
tenna (50 Ohm load Impedance)
3. Connect the Amplifier DC power Cable to a suita-
ble 13.8VDC (± 1V) 40A Power Supply or Auto
Battery. Pay attention to the correct polarity
4. Make sure that the amplifier is switched off
5. Adjust the Transceivers RF output power to 5W
(6W max) if it is capable of more than 5W output
6. Switch on the Amplifier and start operating
7. Check that the antenna VSWR is acceptable with
the amplifier in use. Any large increase in VSWR
indicates that the Antenna is not suitable for the
power being used. Operation should be halted
immediately to avoid damage to the Amplifier /
Radio / ATU etc.
