ADJUSTMENTS
Seat Removal
Fold down the back of the seat. Unscrew
the hand knob under the seat and remove
from the seat post.
Seat Height Adjustment
Remove seat as described above. Slacken
the lower hand knob. The seat height can
be adjusted to 5 different settings by
inserting the steel locking pin into the
required hole (Fig. 2). Re-tighten lower
hand knob and replace the seat.
Scooter Length
The wheelbase can be lengthened or
shortened depending on its existing
settings. The standard length of the
scooter is 92cm (37”) and this can be
extended to 102cm Seat post (40”). To
adjust the wheelbase remove the seat and
the chassis cover complete with integral
batteries. Remove the locking pin located
at the front of the seat post (Fig. 3),
unscrew the red hand lever in front of the
pin by turning anti-clockwise. Slide the
inner front section until the location holes
become aligned. Re-fit the locking pin and
tighten the red hand lever, ensuring when
fully secured, the lever is facing the seat
post as shown in Fig. 3. Refit the chassis
cover with integral batteries then refit the
seat.
Folding the Tiller
Fold down the tiller by loosening the
hand knob located at the base of the
tiller stem (Fig. 4).
WARNING: Adjusting the seat height
and length of the scooter can affect the
stability and handling characteristics of
device.
