English
English
3
4
•
Open the Battery Compartment at the back of the radio and insert four UM3 batteries
following the polarity diagram shown inside the battery compartment.
•
Batteries should be removed form the compartment if the unit is not to be used for some
time.
•
Flat batteries should be removed from the unit to avoid leakage
RADIO OPERATION
Antenna
For FM & DAB reception there is a built-in telescopic FM antenna (16) at the rear of the unit.
Extend the antenna and move it around to obtain the best reception.
If the radio is powered up and switched on for the first time, it will automatically enter into the
DAB mode and perform auto scan function. During the scan the display will show “Scanning
…” together with a slide bar that indicates the progress of the scan and the amount of stations
that have been found so far.
Once the scan has finished, the radio will select the first alphanumerically found station. To
explore the found stations, repeatedly turn the SELECT control (4) and when you find a
station that you would like to listen to, press the SELECT button (4).
Note: If there is no stations found after auto scan, the radio will then enter into the
Tune Select Menu, you can now turn the SELECT control followed by pressing on the
SELECT button to select “Manual tune” or “Autoscan” for stations.
DAB AUTO SCAN
The auto scan will search for the entire DAB Band III channels. After the scan has finished, the
first alphanumerically found station will be automatically selected.
1. To activate auto scan, first press the MENU button to enter into the Tune Select Menu, then
repeatedly turn the SELECT control to select “Autoscan”, finally press the SELECT Button to
confirm, the display will show “Scanning …” and a progressing slide bar.
2.
All the stations that have been found will be stored automatically, to explore and select
listening to the found stations, repeatedly turn the SELECT control followed by pressing on the
SELECT button.
DAB MANUAL TUNING
1. To select manual tune, first press the MENU button to enter into the Tune Select Menu,then
press the SELECT button to select “Manual tune”.
2. Repeatedly turn the SELECT control to move through the DAB channels, the display will
show “5A to 13F” and their associated frequencies.
3. When your desired frequency appears in the display, press the SELECT button to confirm.
The name of the station group (ensemble/multiplex) will be displayed.
4. To listen to the station selected, press on the SELECT button again.
DAB SECONDARY SERVICES
On some occasions you will see a “>” symbol directly after the name of the station, this indicates
that there are secondary services available to that station. These secondary services contain
extra services that relate to the primary station. E.g. a sports station
may want to add extra commentaries. The secondary services are inserted directly after the
primary station. To select the secondary station, press on the SELECT button once.
DAB DISPLAY MODES
Every time you press the INFO button, the display will cycle through the following display modes:
Time and date
The time and date will be automatically updated by the broadcasted information; it is no need to
set the clock manually. In the unlikely event that no clock information is received, the display
will show “<TIME/DATE>”.
Frequency
The frequency of the present station will be displayed.
Audio bit rate
The display will show the digital audio bit rate being received.
Signal strength
The display will show a slide bar to indicate the signal strength, the stronger the signal, the
