52
Utilities Continued:
Heating Continued:
Alde Frost Protection Mode
The Alde system will protect itself from freezing by dumping the water in its tank if the temperature approaches freezing.
If your Alde system has dumped, you will need to reset the frost control valve. Open the compartment that houses your Alde, turn the frost
control valve 90 degrees from its tripped position to reset and press the Alde reset button on the side of the control-valve housing. (Picture
52.1)
*Read the Alde Appliance Manual for Specific Operating and Reset Instructions.*
“Note - Never Block or Obstruct the Air Ducting
When Operating Your Furnace.”
Alde Engine-Heat Exchanger and Engine Pre-Heat
The Alde system is provisioned with an engine heat-exchanger. The heat exchanger can pre-heat your engine in cold temps. The switch for
the engine pre-heat is located on the passenger seat pedestal. (Picture 52.2)
Alde Frost Control in Operating Mode.
Turn to Right to Reset if Tripped.
Picture
52.1
Picture
52.2
Alde Engine Pre-Heat Switch Located on
Passenger Seat Pedestal.
Roadtrek Inc.
