23
© Erwin Hymer Group North America, Inc., R00
Table Storage and Rear Lounge Table Setup (Continued)
The table tops are stored in the rear under the drivers and passengers side bolster cushions.
(*Note – Table bottoms fit into base holders to
keep them from moving or rattling while your motorhome is in motion.*) (Picture 22.2 on Previous Page.)
The larger rectangular shaped table fits in the rear underneath the drivers side bolster cushion. (Picture 22.1 on Previous Page.)
The 4-sided cloverleaf table fits in the rear under the drivers side bolster cushion. (Picture 22.3 on Previous Page.)
Each table has a small piece of honeycombed grip liner placed on top when stored. This keeps the cushions from sliding off or moving while
motorhome is in motion. (Picture 22.4 on Previous Page.)
Either table can be used for front or rear dining. The 4 sided cloverleaf table can have anywhere from 1 to 4 sections raised to enlarge your overall
surface area. Please note that 2 sections are raised for rear dining demonstration. (Picture 22.5 on Previous Page.)
To lift a section of the cloverleaf table, reach underneath from one side at a time until you feel the rounded point of the leaf. Grab the front
portion of the leaf and pull directly backwards until leaf section locks into place.
(*Note – Use caution when lifting the leaf sections as to avoid
getting your hand or fingers pinched when the leaf locks into place.*)
To lower an extended leaf section, reach under the leaf and grab the metal hinge. Pull the hinge to the left and push down on the leaf until it
locks in place underneath the table top. (Picture 22.6 on Previous Page.)
(*Note – Use caution when lowering the leaf sections as to avoid
getting your hand or fingers pinched when the leaf locks into place.*)
