57
© Erwin Hymer Group North America, Inc., R00
Solar Panels
Solar Charge Controller
The solar panels will charge your batteries when sufficient light is available. The solar charge controller
is installed at the factory for the type of solar panels and batteries installed in your Roadtrek. EHGNA
strongly recommends that you make no adjustments to the charge controller or it programming. If
equipped with a display, the charge controller displays either system voltage or amperes generated by
the panels. (Picture 57.1)
*Read the Solar Charge Controller Manual for Specific Operating, Storage and Coolant
Information and Instructions.*
Outlets
There are numerous outlets throughout your Roadtrek consisting of 12-Volt, USB and 110 power.
(Picture 57.2)
The electrical outlets in the kitchen galley and behind the 2
nd
row passenger seat are GFCI (Ground Fault Circuitry Interrupt). If either of the outlets
trips, press the reset button in the middle of the plug. If there is no power to any non GFCI outlets, check each GFCI and reset as needed. (Picture
57.2)
There is an exterior 110-Volt plug located on the passenger side of the vehicle located just in front of the rear axle. (Picture 57.4)
Exterior 110-Volt Outlet.
GFCI and 12-Volt Outlets.
Picture 57.1
Picture 57.4
Picture 57.3
Picture 57.2
110-Volt Power Outlet
Solar Charge Controller Located in
Cabinet Over 2
nd
Row Captain’s Seat.