HOWTO: De-Winterizing
129
© 2016 by Erwin Hymer Group North America, Inc.
Instant hot water dispenser filter
•
• Run the galley faucet for several minutes. If you smell chlorine, your system is
safe to use. If you do not smell chlorine or your water is foamy, or has a
pungent odor, repeat this step.
•
• Drain completely, fill fresh water tank with clean water, run all faucets for 2-3
minutes each.
•
• Hold the instant hot water dispenser taps, both hot and cold, open for several
minutes until the water runs clear and smells like chlorine. The hot water
reservoir has a capacity of about a gallon, so this will take some time. After all
the antifreeze is out of the system, remove the old water filter cartridge in the
cabinet under the microwave, and replace with a fresh filter cartridge.
•
• To help get rid of the residual chlorine smell, pour a cup of vinegar into the
fresh water tank, fill, let sit for a few hours, run the faucets for a minute or so
apiece, drain the tank to ground, and refill with fresh water.