Roadtrek Inc.
25
Shower
Using the Shower
•
Unscrew the drain stopper in the center of the bathroom floor (Picture 25.1)
•
If the shower hose is disconnected, connect it to the threaded fitting behind the sink faucet
handles (Pictures 26.1, 26.2)
•
Release the hook and loop fastener straps retaining the shower curtain
•
Slide the shower curtain along its track to enclose the shower space
•
Once ready, pull up on the knob located between the sink faucet handles to start the flow of
water
•
Adjust the water temperature as needed using the cold and hot water knobs on the sink faucet
After Showering
•
Turn off the water using the hot and cold knobs on the sink faucet
•
Push the knob located between the sink faucet back down to switch the flow of water back to
the sink faucet
•
Refasten the drain stopper in the center of the bathroom floor (this is important as it stops the
content of the grey water from sloshing into the shower area while the vehicle is in motion)
•
Dry the shower curtain with a towel or allow it to air dry before storing it
Picture 25.1
