- Open box, tilt onto open side, slide box up
- Undo 4 cover straps
- Set extrusion rails aside
- Undo 2 side straps
- Open tent, remove ladder, cover, boot bags, gear
hammocks, and hardware bag, leave window poles,
close tent
- Flip to side with 4 holes
- Cut off plastic cover
- Align extrusion rails
- Slide nuts into rails
- Locate holes on opposite side, push bolts through
tape, tighten
- Flip tent
- Cut off plastic cover, remove tape
- Align brackets
- Locate holes on opposite side, push bolts through
tape, don’t tighten
- Align ladder, feed bolts through, tighten
- Tighten brackets
- Install boot bags and gear hammock
- Secure ladder strap
- Install cover
- Lift onto vehicle
- Drop botls through slides and slide into rails
- Sandwich rack with plate and tighten
- Install extrusion end caps
- Undo 4 straps
- Flip back cover, slide out of frame
- Undo side straps
- Undo ladder strap
- Extend ladder, use to lever open
- Pull out ladder awning pole, flip out brackets,
insert, velcro
- Grab bag of poles, insert into frame, bend and
insert in awning
- Roll up window covers
- Lift ladder, zip on annex, zip on floor
- When closing, use bungees
- Remove cover
- Insert annex cord into frame
- Fold up ladder
- Zip annex on
- Layout and zip on floor
- Fold ladder back down
SOME ASSEMBLY REQU’D
Installing the mounting rails:
1) You’ll need to remove the black stickers covering both sides of the 4 bolt
holes, 8 total. To reach the ones inside, reach through one of the tent doors/
windows and under the mattress.
2) Take the mounting rails and align them with the holes.
3) Grab the mounting rail hardware and remove the nylock nuts. Slide the nuts
into the central channel on the mounting rails and align them with the holes.
4) Now take the bolts with washers and slide them up through the holes from
inside the tent and tighten.
Installing the ladder:
1) Flip the tent over so the side with the velcro tie-down is facing
up. Again, start by removing the black stickers covering both sides
of the 2 bolt holes, 4 total.
2) Remove the bolts from the ladder mounting brackets and align
the brackets with the holes.
3) Feed the 4 longer bolts with washers through the top and screw on the nylock
nuts by reaching inside the tent.
Do not tighten yet!
4) Lay the ladder with the buttons facing up and align with the brackets. Use the
shorter bolts and remaining hardware to attach the ladder and tighten. Note: the
order of the hardware should be:
Bolt -> Metal washer -> Bracket -> Plastic washer -> Ladder -> Nylock nut
5) Tighten the nuts attaching the ladder brackets to the tent frame.
6) Use the velcro tie-down on the base of the tent to secure the bottom rung of
the ladder.
4
