- Open box, tilt onto open side, slide box up
- Undo 4 cover straps
- Set extrusion rails aside
- Undo 2 side straps
- Open tent, remove ladder, cover, boot bags, gear
hammocks, and hardware bag, leave window poles,
close tent
- Flip to side with 4 holes
- Cut off plastic cover
- Align extrusion rails
- Slide nuts into rails
- Locate holes on opposite side, push bolts through
tape, tighten
- Flip tent
- Cut off plastic cover, remove tape
- Align brackets
- Locate holes on opposite side, push bolts through
tape, don’t tighten
- Align ladder, feed bolts through, tighten
- Tighten brackets
- Install boot bags and gear hammock
- Secure ladder strap
- Install cover
- Lift onto vehicle
- Drop botls through slides and slide into rails
- Sandwich rack with plate and tighten
- Install extrusion end caps
- Undo 4 straps
- Flip back cover, slide out of frame
- Undo side straps
- Undo ladder strap
- Extend ladder, use to lever open
- Pull out ladder awning pole, flip out brackets,
insert, velcro
- Grab bag of poles, insert into frame, bend and
insert in awning
- Roll up window covers
- Lift ladder, zip on annex, zip on floor
- When closing, use bungees
- Remove cover
- Insert annex cord into frame
- Fold up ladder
- Zip annex on
- Layout and zip on floor
- Fold ladder back down
SOME ASSEMBLY REQU’D
Installing the boot bags and gear hammock:
1) Install the boot bags by sliding the top end into the frame
on the side where the ladder is mounted.
2) Install the gear hammock by clipping to the D-rings around
the base of the tent.
Installing the cover:
1) Unfold the cover and you’ll see that both sides of the
zipper are attached to it. Start by unzipping it so you have
the long corded side completely separated.
2) With the ladder facing up and the hinge side closest to
you, begin by the left hinge on the lower corner (nearest the
ground.) Find the end of the corded side of the zipper with
the starting guide. Feed it into the channel in the frame and
pull it around clockwise. It will cover 3 sides (not the hinge
side) so the starting guide should end up by the right hinge.
3) Install the PVC cover by finding the corded side and
feeding it into the same channel as the zipper along the
hinge side. You can now pull it over the tent and zip it closed.
4) There are 8 buckles attached to the cover. Both ends are
clipped together but the webbing is not attached to the
bottom side. For each buckle, find the webbing attached to
the frame and feed it through the bottom side of the buckle.
5
