3
Regularly inspect the electrical supply cord and
plug and discontinue use immediately if
damage is found. Return to manufacturer or
authorised repairer for repair prior to use.
This appliance contains no user-serviceable
parts. Roband Australia, one of our agents, or a
similarly qualified person(s) should carry out
repairs.
Keep cord away from heated surfaces.
Do not remove any cover panels from the
appliance.
Roband will accept no liability if:
Non-authorised personnel have tampered
with the appliance
The instructions in this manual have not
been followed
Non-original spare parts are used
There is any damage to the unit
CLEANING & MAINTENANCE
CAUTION: Disconnect from power and allow to
cool before cleaning.
The Urn is primarily intended for heating pure
water only, and if so it can be kept filled with
water overnight when used often. If any other
types of liquids are being heated then the urn
should be emptied daily, cleaned and dried
inside and out. Note that heating liquids other
than water may void warranty.
In bore water areas (i.e. where tap water
contains excessive minerals), use distilled or
filtered water only. Otherwise rusting may occur.
If the urn is not being used the next day it is
recommended that it is emptied, cleaned and
dried.
After long periods of non-use rinse the urn with
clean water prior to operation.
The inside of the urn should be checked
regularly for any scale or other crusty deposits
that may build up, which are caused by minerals
in the water.
The water should be checked from time to time
to ensure no dust or small insects have found
their way in.
To clean the inside of the urn use a non-metallic
scourer and soapy water, rinsing well with clean
water. Build-up of crusty deposits can be
removed by filling the urn with a solution of 1
part vinegar to 8 parts water and allowing it to
soak overnight without turning the urn on. After
emptying, if any heat stains remain then rub
some baking soda onto it whilst still wet, leave
for a 10 minutes and rub off. This should then
be followed by the usual clean with soapy water
and a very thorough rinsing. Ensure that the tap
is flushed of any residue with clean water. In
areas where water has a higher mineral content
then removal of scale and other deposits will be
required more often.
Do not clean with the use of a water jet or
immerse in water.
Do not use caustic or abrasive cleaning products
as they will damage the appliance.
Wipe all surfaces of the appliance with warm
soapy water using a damp non-abrasive cloth.
Regular cleaning will prevent a build-up of oils
and keep the appliance looking new.
NOTE: The black finish on UDB models is much
more fragile than stainless steel. Extra care is
required when cleaning to avoid chipping or
scuffing the finish. Clean only with soapy water
and a soft cloth. Do not use abrasive pads or
other cleaning agents.
INSTALLATION
Place the urn on a solid, flat level surface with
the tap facing the user. It is highly
