Piezo-Kreisel G 300
No.
8095
13
5.3 Supplementary notes
-
If you are using an RC system with flight mode dependent ATV, e.g. an FC 28,
you can set tail rotor servo travel (ATV) and gyro gain separately for each flight
mode, and these settings can then be called up automatically when you ope-
rate the flight mode switches „Idle-Up 1“ and „Idle-Up 2“.
-
Depending on the combination of main and tail rotor you are using, you may
find that the tail boom oscillates (swings from side to side) slightly. This may
be due to an excessively high gyro gain setting, but it can also be the result of
tail rotor blades which are too long or too wide. In this case the solution is to
shorten the tail rotor blades by about 3 - 5 mm.
-
When the gyro is switched on it detects and stores the configuration of the tail
rotor and Aux channels and the position of the REV switch. If you ever need
to connect the „Aux“ and „Rx“ plugs to different receiver sockets, or if you use
the reverse function, it is then necessary to switch the gyro off and on again
so that it can read in the new configuration and store it.
6. Specification:
Operating voltage:
3 - 8 Volts, from receiver battery
Current drain:
approx. 25 mA (at 4.8 V)
Dimensions:
approx. 41 x 41 x 20 mm
Weight:
approx. 30 g
7. Contents of set
Piezo-Gyro G 300
self-adhesive strips of damping foam
operating instructions
robbe Modellsport GmbH & Co. KG
We reserve the right to alter technical specifications
