14
10. Appendix- Changing the power supply settings
Both the transformer and the ballast must be connected correctly for the local AC voltage and frequency.
The wrong settings can cause poor performance or demage of the moving head.The factory settings are printed
next to the power cord.
If you want to change the power supply settings,follow the instructions:
UE version:
1.Disconnect the fixture from AC power.
2.Remove the control board cover by loosening the 4 screws.
3.Move the wire 1 on the transformer connection block to the position according to the desired voltage.
Example:
4.Put the cover back before applying AC power.
Transformer
Ballast
Control board cover
Front cover
Fastening screws
Fastening screws
Summary of Contents for DJ SCAN 150 XT
Page 1: ......
