Robe Fog 1500FT, User Manual

6

7

In general, Fog 1500 FT conform to the following performance specifications:

1. Average Operating temperature = 2500°C

2. Fog 1500 FT can maintain maximum output for 60 seconds or more.

5. Technical specifications

Power supply:

Power consumption: .......... 1430 VA

Voltage: ............................. AC 230 V, 50 Hz

Fuse: ................................. T7 A@230V

DMX:   

3 pin and 5 pin XLR sockets

Tank capacity: 

6 Liter

Output: 

20.000 Cu.ft/Min.

Output pressure: 

49 kPa

Heat Up time:   

11 min.

Liquid cons. rate: 

13 Min/Liter (100% output)

Dimensions:   

645 x 240 x 190 mm 

Weight: 

15,5 kg

6. Performance Notes

Set the volume to „Nonstop Burst“ to have continuous output. When in such setting, the thermostat keep 

detecting heater temperature and adjust output automatically.

Fog 1500 FT has a recycling period after long bursts when the machine will shut itself down for a short period 

in order to heat up again. During this time, no fog can be produced.

Fog 1500 FT may sputter small amounts of fog occasionally during operation and for a minute or so after 

being turned off.

7.Configuration the pump power for local AC power.

The device pump is factory configured for 230V/50Hz.If your AC power is different,the pump power can be 

configured for the local voltage using the follow procedure: 

 1. Press the Function Key  and turn on the machine at the same time.

 2. Continue to press the Function Key for about 5 sec.

 3. „ROBE“ logo will appear on the display and  after that message „Voltage change“

 4. press the Enter Key

 5. The current voltage will appear on the display.Use Up and Down Keys to  choose the one you need:

110V  50-60Hz

120V  50-60Hz

220V  50-60Hz

230V  50-60Hz

240V  50Hz

 6. Presss Enter Key after chosen the voltage

 7. The main screen will appear on the display

8. Maintenance and cleaning

Do not allow the fog liquid to become contaminated. Always replace the caps on the fog liquid container and 

the fog machine liquid tank immediately after filling.

After every 40 hours of continuous operation, it is recommended to run a cleaning solution composed of 80% 

distilled water and 20% white vinegar through the system to prevent the accumulation of particulate matter in 

the heating element. The recommended cleaning regimen is as follows: