3.Unpacking
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact.Shipping carton should
contain the following items:
1.Fog 850 FT
.Remote control
.User manual
Before beginning initial setup of your ROBE Fog Machine, make sure that there is no evident damage caused by transportation. In
the event that the unit's housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your ROBE
distributor for assistance.
4.Setup
Remove all packing materials from shipping box. Check that all foam and plastic padding is removed, especially in the nozzle area.
Place fog machine on a flat surface and remove fog liquid tank cap.
Fill with only an original liquid recommended by ROBE distributor. Other liquids may cause spitting and serious clogging problem and
could result in the production of an unhealthful fog. The use of other liquids voids the warranty of the Fog 850 FT. When filled, place
cap back on liquid tank.
Your hazer may be operated with or without a remote controller. If you will be controlling your unit remotely, firmly attach the remote
control cable to the proper input.
WARNING:
Use of any liquid other than original liquid recommended by ROBE distributor or modification or attempted to unauthorized repair of
the Fog 850 FT will immediately invalidate the warranty.
5.Operation
Carefully add fluid to the liquid tank.Do not overfill the tank.
Plug power cord into a grounded electrical outlet. Turn power switch on rear of the unit to " ON " position. The red (green) light on the
handle (remote control) will be blinking when the power is "ON".
The machine will now begin warming up.Warm-up is complete when the red lamp permanent lights on the button of the handle (or
green lamp permanent lights on the remote control -if it is connected).
To emit fog, press the button on the handle (on the control module-if it is connected) and hold for the desired length of time.
Always monitor liquid level to prevent the machine running out of liquid.The fluid level can be monitored by looking at the fluid tank´s
window on the back of the machine.
Caution: "Visibility during operation is reduced"
This model can be operated at a floor level or sitting on any regular surface.Whatever installation method you choose,do not allow the
unit to have more than a 15 degree angle of inclintion.
Important!
Always monitor tank liquid level as you are fogging. Running a fog machine with no
liquid can permanently damage the unit.
Note: A fluid level sensor is installed on the unit. The machine will stop to fog if the fluid is lower than usable level.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the external fuse, remote control
connection and power from the wall. If all of the above appears to be O.K., plug the unit again. If fog does not come out after holding
the remote button down for 30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose. If you
are unable to determine the cause of the problem, do not simply continue pushing the remote button, as this may damage the unit.
Return the machine to your Robe distributor.
