Robin CycFX 8
7
To build a DMX chain
1.
Connect the DMX output of the controller directly with the DMX input of the first fixture in the DMX chain.
2.
Connect the DMX output of the first fixture in the DMX chain with the DMX input of the next fixture.
3.
Always connect the DMX output with the input of the next fixture until all fixtures are connected.
Do not overload the link. Max. 32 fixtures may be connected on a DMX link.
Caution: Terminate the link by installing a termination plug in the output of the last fixture. The termination plug is
a male 3-pin XLR plug with a 120 Ohm resistor soldered between Signal (–) and Signal (+).
3.4 Wireless DMX operation
The wireless version of the Robin CycFX 8 (Robin CycFX 8/W) is equipped with the Lumen Radio CRMX module and
antenna for receiving DMX signal. CRMX module operates on the 2.4 GHz band.
1.
Select wireless DMX input from the menu
PErS
(PErS-->dM.IM.-->dM.UL.).
2.
To link the fixture with DMX transmitter.
The fixture can be only linked with the transmitter by running the link procedure at DMX transmitter .
After linking , the level of DMX signal ( 0-100 %) is displayed in the menu
item “r
.InF
“ (SPEC-->rAdI.--> r.InF.)
3.
To unlink the fixture from DMX transmitter.
The fixture can be unlinked from receiver via the menu item “ r
.UnL
.“ (SPEC-->rAdI.--> r.UnL.).
Summary of Contents for Robin CycFX 8 wireless DMX CRMX
Page 1: ...Version 1 4 ...
Page 26: ...Robin CycFX 8 26 Beam distribution ...
Page 27: ...Robin CycFX 8 27 ...
Page 29: ...Robin CycFX 8 29 ...
