69
9. Maintenance
Fig. 63: Section of tamping pick with tapping device attached
1
Knocking device (optional)
7
Sleeve of floating bearing
2
Intermediate shaft
8
Unbalance
3
Rubber damper
9
Eccentric shaft
4
Fixed bearing
10
Flange of tamping pick
5
Tamping pick
11
Nut and Bolt (M10)
6
Floating bearing
12
Fastening screws engine shaft
Fig. 64: Knocking device
Order Number for knocking device:
EDP. No. 899 895 0001
2.
Dismount the whole assembly (the tamping pick) off the
vertical tamper: Untighten the screws M10 (11) of flange
(10) with open-end spanner AF17 and the two screws M8
(12) that attach the coupling element to the engine shaft
(under rubber bellow) with Allen key AF6.
3.
Detach tamping pick together with eccentric shaft (9) from
vertical tamper.
4.
Attach knocking device (1) with screws M10 (11) to flange
(10).
5.
Put drain tray on a rigid work surface.
Summary of Contents for 62.05L
