7. Transport and storage
42
2.
Make sure to lay down the machine only in the same man-
ner as shown in the picture with the protection shield point-
ing upwards (see arrow).
Fig. 33: Laying down the machine
7.2
Storage
The temperature range for storing the machine is -20°C to
+60°.
Ensure that the place of storage is dry and dust-free.
NOTICE
Risk of damage!
The oil can leak from the tamping pick the moment it is
higher than the engine.
►
Always store the vertical tamper with its motor to the top.
1.
Make sure that the storage location is free of excessive
moisture and dust.
WARNING
Risk of fire or explosion!
Petrol is extremely flammable and is explosive
under certain conditions.
►
Obey the safety notes concerning the
combustion engine and fuel in Chap. 2.
2.
Drain off the fuel:
3.
Make sure that the oil filling cap is tightened securely.
4.
Unscrew the fuel tank cap and drain the fuel into a suitable
container. To do this tilt the engine towards fuel filler neck.
5.
If there is any foreign matter remaining in the fuel tank,
remove it completely.
6.
Pull out the fuel filter from the refill port using a wire.
7.
Press in the starter pump button several times until all the
fuel in the fuel return line has been pumped back into the
fuel tank.
8.
Tilt the engine towards the fuel filler neck to let the fuel in
the fuel tank flow into the container.
Laying down the machine
Before putting the machine
into storage for a prolonged
period
Summary of Contents for 62.05L
