53
9. Maintenance
9.3.4
Idle adjustment
1.
Start engine and allow to warm up.
2.
Push throttle lever to the "MIN" position
Tool
•
Screwdriver
Fig. 38: Screw T (idle)
•
If idle is too high, turn screw T (1) ccw.
•
If idle is too low (engine stops), turn screw T (1) cw.
Nominal value of idle RPM: approx. 1100 RPM.
9.3.5
Reset carburetor to factory setting
If multiple changes have been carried out on the carburetor
without success, it might be beneficial to reset the carburetor
to the original setting and start adjustment again from this
point.
Tool
•
Screwdriver
Fig. 39: Screws L (1) and H (2)
1.
Tighten the screw H (2) fully (CW), then turn it 2 turns in the
opposite direction (CCL)
2.
Tighten the screw L (1) fully (CW), then turn it 2 ½ turns in
the opposite direction (CCL)
Factory setting of the carburettor has been restored,
suitable for an altitude of 400 m MSL.
Summary of Contents for 62.05L
