EN
EN -1-
1
User’s instructions
GENERAL INSTRUCTIONS
1.
Not for residential use.
2.
These fixtures must only be serviced by a qualified technician.
3.
In addition to the instructions indicated on this page, relevant health and safety requirements of the appropriate EU
Directives must be adhered to at all times.
4.
This fixture is in compliance with section 17
– Lighting appliance for theatre stages, television, cinema and photograph
studios. Standards NF EN 60598-1 and NF EN 60598-2-17.
5.
This fixture is rated as IP20, and is for indoor use only.
FIXTURE
6.
Warning: disconnect from mains supply before servicing.
7.
Ensure fixture is correctly mounted on an appropriate support.
8.
Protection screens, lenses and filters must be replaced in the event of any damage, such as cracks or deep scratches,
since these might reduce performance.
9.
When hung or flown the fixture must be secured by an additional hanging accessory (such as a safety cable or bond) of
suitable length.
10.
Safety bonds or cables must be securely attached to the back of the fixture and be as short as possible, or rolled up as
necessary, to minimise travel distance should the fixture be dislodged.
11.
Movable accessories (barn doors, spill rings etc.) must also be secured with a suitable safety cable or bond at the front of
the fixture.
12.
The combined weight of both the fixture and the accessories must be considered when choosing the load-bearing
capability of safety cable or bond.
13.
Do not open lighting fixture when the lamp is ignited.
14.
Warning: Both lamp and lamp housing become hot during use. Allow fixture to cool before servicing
15.
Do not tamper with design of fixture nor any of its safety features.
16.
Tighten electrical mains cable connections regularly and replace with one of identical specification if damaged.
17.
Use only with correct power supply.
VENTILATION
18.
Keep well away from flammable material.
19.
Not for outdoor use. Do not cover. Do not permit fixture to get wet.
20.
To avoid overheating, do not obstruct air vents.
21.
Ensure any cooling fans are in correct working order. If fans are not working, turn fixture off immediately and service as
necessary.
LAMP
22.
Check that the lamp voltage corresponds to the mains voltage used. Only use a lamp of type and voltage indicated on
lamp housing or packaging.
23.
Replaced lamp if damaged or deformed by heat.
24.
Ensure lamp is correctly fitted before use.
CLEANING
25.
Clean all optical parts (lenses, lamps, etc.) with alcohol-based cleaner.
26.
Regularly remove dust from mirror with a soft, clean cloth.
27.
Clean all filters regularly.
PLEASE NOTE
These products have been built to conform to European standards relating to professional lighting equipment. Any modification
made to our products will void the manufacturers' warranty.
Summary of Contents for TIBO 503
Page 12: ...FR FR 10 3 3 Accessoires 3 3 1 Porte filtre avant Etape 1 Etape 2 3 3 2 Porte gobo iris ...
Page 31: ...EN EN 9 3 3 Accessories 3 3 1 Front filter holder Step 1 Step 2 3 3 2 Gobo holder iris ...
Page 33: ...EN EN 11 3 3 4 Optics Zoom 30 45 zoom 15 35 factory settings 30 45 Step 1 Step 2 Step 3 ...
