18
CORAYVAC
®
HEATING SYSTEMS
Operation and Maintenance
WARNING
Installation, Service and Annual Inspection of heater
must be done by a contractor qualified in the
installation and service of gas-fired heating equipment.
Read this manual carefully before installation,
operation, or service of this equipment.
Failure to follow these instructions can result in death,
injury or property damage.
Do not store or use flammable objects, liquids or vapors near
the heater.
Immediately remove these items if they are present.
Maintain the clearances to combustibles.
Do not hang anything from, or place anything on, the heater.
Make sure nothing is lodged underneath the reflector, in
between the heat exchanger tubes or in the decorative or pro-
tective grilles (included with select models).
Immediately remove objects in violation of the clearances to
combustibles.
Make sure there is no dirt, sagging, cracking or distortion.
Do not operate if there is sagging, cracking or distortion.
Make sure reflectors are correctly overlapped.
Clean outside surface with a damp cloth.
Venting must be intact. Using a flashlight, look for obstructions,
cracks on the pipe, gaps in the sealed areas or corrosion.
Do not operate if there are obstructions, cracks, gaps or corrosion.
The area must be free of dirt and dust.
Remove any carbon deposits or scale using a wire brush.
Inlet must be intact. Look for obstructions, cracks on the pipe,
gaps in the sealed areas or corrosion.
Do not operate if there are obstructions, cracks, gaps or corro-
sion.
The area must be free of dirt and dust.
Clean and reinstall as required.
The Vicinity of the Heater
Vehicles and Other Objects
Reflector
Vent Pipe
Outside Air Inlet
REMEMBER TO CHECK:
