Cutting Preparation
Adjust the angle attachment to desired
angle as needed.
The angle attachment can be used
on the left side of the table as shown.
Warning: Do not put your fingers
against the sharp edge of the blade at
any time.
CUTTING
Straight Cutting
Insert material between the cutting
blade and the base, flush with the
angle attachment as shown and hold
the material with foot then push
handle down to complete a cut.
Warning:
Maintain control of the
handle. Do not allow handle to
slam back after making a cut.
45° Cutting
Swing the angle attachment to 45°.
Insert material between the cutting
blade and the base, against the angle
attachment as shown, then push the
handle down to complete a cut.
Warning:
Maintain control of the
handle. Do not allow handle to slam
back after making a cut.
-4-
Summary of Contents for 10-66
Page 6: ...PART LIST 6...
Page 12: ...LISTE DES PI CES D TACH ES 12...
Page 18: ...LISTA DE PARTES 18...
