Operating your radio - FM auto-tune
1. Fully extend the wire aerial located on the rear of your radio. Place
the wire antenna so that it is as straight as possible extending either
above or below the radio.
2. Press and release the
On/Off
button to switch on your radio.
3. Repeatedly, press and hold the
Mode
button until the FM mode is
selected.
4. Rotate the
Tuning
control clockwise and then press and hold the
Tuning
control for 2 - 3 seconds to cause your radio to search from
low frequency to high frequency and to stop automatically when it
fi
nds a station of suf
fi
cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio may display the station name.
6. To
fi
nd other stations press and hold the
Tuning
control as before.
7. Rotate
the
Tuning
control anti-clockwise and then press and hold the
Tuning
control for 2 - 3 seconds to cause your radio to search from
high frequency to low frequency and to stop automatically when it
fi
nds a station of suf
fi
cient strength.
8. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
9. Adjust
the
Volume
to the required setting. To switch off your radio,
press and release the
On/Off
button.
13
2,9
3
4-7
9
9
