5
Operating your radio
1. Press and release the
On/Off
button to switch on your radio.
When
fi
rst switched on, the radio will be in DAB mode. After each use
the radio will remember the mode used and then switch on in that
mode the next time that it is used.
2. If the radio has been used before, the last used station will be selected.
3. If this is the
fi
rst time that the radio has been used a scan of the Band
III DAB channels will be carried out (depending on whether scanning
was already completed in standby mode). During the scanning process
the display will show the progress of the station search. The number
on the right of the display is the number of stations that have been
found.
4. When the scan is completed the
fi
rst station (in numeric-alpha order
0...9, A...Z will be selected. The
fi
rst station in the list of stations found
during scanning will be played. The display will show the station name.
5. If no signals are found then it may be necessary to relocate your radio
to a position giving better reception. You should then carry out a scan
to
fi
nd stations as described on page 9.
•
Your radio has an indicator
on the display to indicate the strength
of the DAB radio signal being received.
Note:
When
fi
rst switched on, the radio will set the volume to a moderately
high level, in case the broadcast is very quiet. After you have set the volume
using the
Volume Up
or
Down
buttons, the radio will remember the setting
that you have applied for the next time that it is used.
1
