iPod Remote Control operation
1. Carefully plug
into your iPod docking connector checking that the
connector is correctly aligned (see Connecting to your iPod, page 25). Plug
the headphones into
.
2. Your iPod may power up when
is connected. If not, press and hold the
Play / Pause
button on
to switch on your iPod.
will then power
up after 2 - 3 seconds. The display will show ‘Welcome’ and then
will
enter the last used operating mode.
3. If necessary, press and release the
Mode
button until Remote mode is selected.
will show ‘Remote’ on the display.
4. Use the controls on your iPod to select the Artist / Album / Playlist as normal.
You can then optionally set the hold switch on your iPod.
5. Use the
Play / Pause
button on
to start playback from your iPod.
6. Set the volume using the
Volume Up
and
Down
buttons on
.
23