SYSTEM SETTINGS
page 1 of 5
NOTE:
Only the installing contractor should set System Settings.
Choose
System Settings
from the
Main Menu
.
The
System Settings Menu
gives nine more ways to get the most from the thermostat.
The information below describes how these features enhance thermostat performance.
Equipment Setup
– Make selections about the types of equipment used in your heating/cooling system.
First, choose what type of equipment is used for the 1st Stage Heat.
Choices are:
None
,
Furnace
(e.g., gas forced air furnace),
Strip
(e.g., electric baseboard
heating), or
Heat Pump
.
On C9725i2 models, choose 2nd Stage Heat.
Choices are:
None
,
Furnace
,
Strip
, or
Heat Pump
.
If
Heat Pump
is chosen for the
1st Stage Heat
and
Furnace
is chosen for the
2nd Stage Heat
, two new menu items will appear on
the
Equipment Setup Menu
;
Comp. Type
and
2nd Stage Fan
.
The
Comp. Type
allows you to determine how 1st and 2nd stage heat work together.
Add-On
– 1st stage heating compressor on the heat pump will be turned off when 2nd stage heating is activated.
Standard
– 1st stage heating compressor will continue to operate with the 2nd stage furnace for added heating.
The
2nd Stage Fan
determines how the fan will operate.
Plenum
– Allows the furnace to control the fan.
ON
– Allows the thermostat to control the fan.
19
Main Menu
Back
Select
Comfort Settings
User Preferences
System Settings
User Security
Equipment Setup Menu
Back
Select
1st Stg Heat
Heat Pump
2nd Stg Heat
Furnace
Comp. Type
Standard
2nd Stage Fan
Plenum
System Settings Menu
Back
Select
Equipment Setup
Residual Cool
60Sec
Balance Points
Service Intervals
