13
AutomaticShut-Down
The thermostat will not display the room temperature if the temperature
goes higher than 99 °F (37 °C) or lower than 32 °F (0 °C).
The display will show HI or LO. The thermostat continues to control
heating and cooling and will resume the display of real time information
when the room temperature is back inside the display’s range.
SettingtheFanToON,AUTOorCIRC
The fan has 3 settings: On, Auto, or Circ. Press the button to switch
among the three.
ON: The fan is on constantly. The room temperture, set points, and
status of the heating and cooling equipment has no effect on the
fan.
AUTO: When there is a call for heating or cooling the fan will turn on.
CIRC: The fan operates in a cycle of on for 10 minutes and off for 20
minutes. When there is a call for heating or cooling the cycle stops
and the fan responds to the call. The fan circulation cycle resumes
when the call for heating or cooling is satisfied.
Troubleshooting
If problems with thermostat cannot be resolved, call:
www.invensyscontrols.com
or
Technical Support: (800) 445-8299
Problem
Action
Thermostat does not turn on system.
Check wiring.
(See
Wiring Diagrams
section.)
System turns on too often.
Increase temperature differential.
(See
To Make Changes to the Settings
section.)
System fan does not operate properly.
Move fan option switch to either gas
or electric, to match system.
(See
Setting the Fan to ON, AUTO, or
CIRC
section.)
Thermostat does not display proper
room temperature.
Check F/C (Fahrenheit/Celsius) setting.
(See
To Make Changes to the Settings
section
.)
Display shows HI or LO and room
temperature is normal.
Call a licensed service person to
replace/repair.
Summary of Contents for RS6000
Page 15: ...15 NOTES...
