(C)
•
Timer #3 – Bottom Row
(B)
•
Timer #2 Middle Row
•
Resets/Clears All Timers
(A)
•
Timer #1 – Top Row
•
In “ALL”, Starts all timers
Identifies the
location of
Timers 1,2 &3
Simultaneous Starting Time – All Start Together
Should you want to start all timers at the same time, select “ALL” during the Set-Up procedure. “SEP”
will disappear. You may take up to 1000 reading(s) for each timer.
Press (A) to start timing. Then, press (A) for Timer #1, (B) for Timer #2 and (C) for Timer #3, as required.
The time will appear frozen and the lap counter will register each time a reading is taken. You may press
(E) to release the display to the current running time or the SC-888 will automatically do so after 15
seconds. Upon release of the previous reading, the lap counter will increase by one to reflect the current
lap number.
Upon completion of the event, press and hold (A), (B) and/or (C) for two (2) seconds to stop timing.
“STOP” appears. The brackets below the Lap Counter stop flashing. The time reading shown at “STOP”
will be the actual finish time (not two (2) seconds later).
While all timers are stopped, press (B) for two (2) seconds to reset to all zeros.
Separate Starting Time(s)
Should you want to start each timer on its own, select “SEP” during the set-up procedure, “SEP” will
appear.
