RG - SERIES
APPROVED Page 5 of 9
ISSUE: F
ECN 07 033
SECTION 1.
MOTOR REMOVAL AND REPLACEMENT
1.1
REMOVE DIFFUSER AND LIGHT BULB
1.2
REMOVE FINGERGUARD AND FANBLADE
1.3
REMOVE REAR COVER
1.4
REMOVE FILTER SPRINGS AND LOCATING SCREWS ON MOTOR
HOUSING
1.5
LIFT MOTOR HOUSING FRONT EDGE, DRAW POWER CABLE
THROUGH BACK
1.6
DISCONNECT SWITCHES
1.7
REMOVE MOTOR HOUSE FROM BODY AND TURN UPSIDE DOWN
ON TOP OF BODY
1.8
REMOVE MOTOR NUTS AND WASHERS
1.9
DRAW MOTOR DOWN, AWAY FROM MOUNTING BRACKET TO SHOW
MOTOR
1.10 CUT WIRES FROM NEW MOTOR KIT. LEAVE ABOUT 3 OR 4mm OF
COLOUR ON RED, BLACK AND WHITE WIRES (DO NOT UNSOLDER
THESE WIRES).
1.11 SOLDER WIRES FROM RANGEHOOD ONTO NEW MOTOR (USE
COLOURS TO MATCH WITH).
1.12 REMOUNT MOTOR TO BRACKET
1.13 REASSEMBLE RANGEHOOD IN REVERSE TO PROCEDURE ABOVE,
TAKING CARE TO PULL AS MUCH OF THE POWER CORD OUT OF
THE BODY AS POSSIBLE
1.14 TEST TO ELECTRICAL SAFETY STANDARDS
