RG - SERIES
APPROVED Page 6 of 9
ISSUE: F
ECN 07 033
SECTION 2.
SWITCH REPLACEMENT
2.1
REMOVE MOTOR HOUSING AS PER THE INSTRUCTIONS IN
SECTION 1
2.2
SWITCHES ARE REMOVED FROM THE INSIDE OF THE RANGEHOOD
BY DEPRESSING THE HOLDING TAGS MOULDED INTO EACH SIDE
OF THE SWITCH
2.3
REPLACE WITH NEW SWITCH, CHECK WIRING AS PER WIRING
DIAGRAM, AND THAT SWITCHES ARE IN THE CORRECT POSITION
SECTION 3.
POWER CORD REPLACEMENT
3.1
REMOVE MOTOR HOUSING AS PER THE INSTRUCTIONS IN
SECTION 1
3.2
REMOVE CABLE CLAMP
3.3
PULL OUT POWER CORD AND REMOVE BY CUTTING OFF THE
CLOSED END CONNECTORS, STRIP AND RECONNECT NEW CORD
USING NEW CONNECTORS – CRIMP SECURELY
3.4
REPLACE CABLE CLAMP
3.5
CARRY OUT EARTH TEST BEFORE CONNECTING TO POWER
