background image

 

MAINTENANCE 

Particular  care  must  be  taken  with  the  grease  filters  which  must  be  periodically  cleaned  (at  least 
every two months).  Remove the grease filters and wash them either by hand using hot soapy water 
or  in  the  dishwasher  using  mild  detergent.  Note-  some  discolouration  of  the  frame  may  occur. 
Caution:  Never  use  abrasive  or  oil  based  liquid  cleaners.    To  clean  the  stainless  steel  and  glass 
components  of  the  appliance  use  mild  detergent  and  warm  water.  In  areas  of  high  humidity  and 
coastal environments cleaning should be carried out frequently.

 

In  the  case  of  charcoal  filters,  these  are  disposable  items  and  it  is  recommended  that  these  be 
replaced every 2-4 months depending on the use of the canopy hood. 
For  other  accessories,  parts  and  service,  please  contact  your  local  supplier  (Refer  to  the  Warranty 
Certificate).

 

 

LIGHT REPLACEMENT  

(

Halogen bulb 12 Volts/10 Watt

1.

 

Switch off the power to the canopy hood and allow the bulb to cool. 

2.

 

Use a small bladed screwdriver to prise off the light cover, taking care not to  

  damage the surrounding material. 
3.

 

Use a cloth to remove the bulb. 

4.

 

Replace with a new bulb using a cloth. 

Do not touch the bulb with fingers

5.

 

Snap the cover back in place. 

 

WARNINGS

 

 

This  canopy  hood  is  not  intended  for  use  by  young  children  or  infirm  persons  without 
supervision. 

 

Young children should be supervised to ensure that they do not play with the canopy hood. 

 

There shall be adequate ventilation of the room when the canopy hood is used at the same time 
as appliances burning gas or other fuels. (A partial vacuum in the room could result in too high a 
concentration of gas in the air) 

 

You must read the details concerning the method and frequency of cleaning (see maintenance). 

 

There is a fire risk if cleaning is not carried out in accordance with the instructions. 

 

Do not flambé under the canopy hood. 

 

Exhaust  air  must  not  be  discharged  into  an  existing  flue  which  is  used  for  exhausting  fumes 
from appliances burning gas or other fuels 

 

The  minimum  distance  between  the  hob  surface  and  the  filters  of  the  canopy  hood  shall  be 
600mm (650mm if installed over a gas hob). 

 

Attention should be given to ensure that any applicable regulations concerning the discharge of 
exhaust air is fulfilled. 

 

If the supply cord of this equipment is damaged it must only be replaced by the manufacturer, its 
service agent or similarly qualified person in order to avoid a hazard. 

 

 

 

ISO 9001/2000 certification

 

New Zealand: Robinhood Ltd 

Tel: 0800 760 667  Fax: 0800 276 246  
Email: enquiries@robinhood.co.nz 
www.robinhood.co.nz 

Australia: Robinhood Australia Pty Ltd ACN  

Tel: 1800 648 556  Fax: 1800 628 577 
Email: enquiries@robinhood.co.nz 
www.robinhood.com.au 

 

RECOMMENDED DUCTING 

SYSTEM FOR RANGEHOODS

 

 

Summary of Contents for RHCI9SS - IMPRESA

Page 1: ... during installation if abraded or knocked by tools Note all ducting must comply with local requirements and building codes A power outlet should be within 1200mm from the motor assembly and can be either on the wall behind the chimney or in the ceiling All electrical work must be done in accordance with local and or national electrical codes as applicable For safety this product must be earthed I...

Page 2: ...CANOPYHOOD C FILTER SURFACE HOB TOP B A A 600mm electric cook top min A 650mm gas cook top min B 485mm C 220 The canopy hood is designed for 2400mm ceilings The chimney is telescopic and is designed for hood installations between 600 to 750mm above the cooking surface Ascertain the desired installation height of the canopy hood Any installation above 750mm will compromise the extraction performanc...

Page 3: ...l Cut the cornice moulding away if required to enable the chimney to fit flush against the wall and ceiling 4 Mark and cut out the hole in the ceiling wall to fit the ducting 170mm dia This is positioned centrally above the canopy hood and 85mm from the wall For ceiling option 5 Using the screws supplied fix the chimney bracket to the wall 100mm below the ceiling checking that it is aligned with t...

Page 4: ...ung children or infirm persons without supervision Young children should be supervised to ensure that they do not play with the canopy hood There shall be adequate ventilation of the room when the canopy hood is used at the same time as appliances burning gas or other fuels A partial vacuum in the room could result in too high a concentration of gas in the air You must read the details concerning ...

Reviews: