Pre-Installation -
continued
Pre-Installation
o
The canopy hood is designed for 2400mm ceilings.
o
The chimney is telescopic and is designed for hood
installations between 600 to 750mm above the cooking
surface.
o
Ascertain the desired installation height of the canopy
hood.
o
Any installation above 750mm will compromise the
extraction performance.
o
The air outlet from the motor requires 150mm round
ducting which requires 170mm diameter hole in the
ceiling.
Installation
1.
Before commencement unpack the canopy hood and
check that it functions correctly.
2.
Use a plumb line to mark the centre of the cooking
surface on the ceiling.
3.
Using the upper support frame as a template mark the
four holes on the ceiling. Ensure that the support frame
front edge is parallel with the bench top and that the
plumb line mark is central to the four mounting screw
holes.
4.
Drill holes in the ceiling at the points marked.
•
When fitting to a 50mm truss drill a pilot hole
through the ceiling and the truss.
•
If securing to any other ceiling type please use
appropriate fasteners and follow their
instructions of use carefully.
5.
For the ducting mark out and cut a Ø170mm hole in the
ceiling.
Note that this hole is not central to the four
mounting screw holes.
6.
Fix the upper support frame to the ceiling using the
screws supplied.
Before drilling any holes check that the area behind the surface to be
drilled is clear of any electrical cables, pipes etc. Fixing to a solid joist or
50mm deep truss is recommended.
Note:
Whenever possible protect the hob top with cardboard or the like.
