2
Installation
UNPACKING THE APPLIANCE
Remove the external & internal packaging.
When unpacking the appliance please check for any damage. If damage is found, do not connect to the power
source and contact the Authorised Service Provider.
Before connecting the appliance to the power source, let it stand upright for approximately 4 hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation. Remove any protective
film from the outer surface.
Clean the interior surface with lukewarm water using a soft cloth.
INSTALLING THE FRIDGE
This appliance is designed to be free standing only, and should not be recessed or built
‐
in.
Place your appliance on a solid, level floor that is strong enough to support the appliance when it is fully loaded. Use
the adjustable feet at the bottom of the appliance to compensate for any unevenness of the floor.
Allow at least 10 cm of space around the back and sides of the appliance, which allows the proper air circulation,
and at least 20cm above the unit.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the appliance not to perform properly. Avoid locating the appliance in moist areas.
Plug the appliance into an exclusive, properly installed
‐
grounded wall outlet. Do not under any circumstances cut or
remove the third (ground prong from the power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician or an Authorised Service Centre.
After plugging the appliance into a wall outlet (220
‐
240V 50Hz, allow the unit to cool down for 2~3 hours before
placing food in the freezer and refrigeration compartments.
If moving the appliance, avoid tilting the appliance more than 45°. At no time should the appliance be turned upside
down.
A method of disconnecting the appliance from the power supply after installation shall be available.
ADJUSTING THE DOOR
The door can be adjusted to open from either the left or right hand side. Follow the instructions below (this is
structured to transfer the door hinges from the right hand side to the left hand side):
1.
Remove the
two screws at the rear side of the top cover.
2.
Remove top cover and place it aside.
3.
Unscrew top hinge and then remove door and place it on a soft pad to avoid scratch.
4.
Unscrew bottom hinge. Then remove the adjustable feet from both sides
.
5.
Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
6.
Refit the bracket fitting the bottom hinge pin. Replace both adjustable feet.
7.
Place the door back on. Ensure the door is aligned horizontally and vertically, so that the seals are closed on
all sides before finally tightening the top hinge.
8.
Put the top cover and fix it with 2 screws on the back.
And fix the thermostat knob.
Summary of Contents for RHUFZ183W
Page 7: ...Troubleshooting ...
