104574 Issue D
ECN: 07 007
C A N O P Y O P E R A T I O N
Thank you for purchasing a quality stainless steel canopy rangehood. We have a high
standard of quality control and each rangehood is tested and approved before it
leaves the factory.
IMPORTANT: Please read prior to installation or operation
Always switch power off prior to installing, servicing or cleaning the appliance.
Never use the appliance without filters.
Please read the notes on general cleaning, especially the filters.
Exhaust air must not be discharged into a heating flue or wall cavity. Unless the
cavity is designed for that purpose.
Areas where the rangehood is installed that also have gas oil or coal fired heaters,
must be well ventilated to prevent a partial vacuum in the room. This includes gas
hobs. (A partial vacuum in the room could result in too high a concentration of gas
in the atmosphere).
The appliance is supplied with an approved power cable which must not be
changed. If the supply cord of this equipment is damaged, it must only be replaced
by the manufacturer or its service agent or similarly qualified person in order to
avoid hazard.
C O N T R O L P A N E L
- 2 -
- 7 -
Key T1
= Turns the lighting system on and off
.
Key T2
= Turns the motor on and off.
Key T3
= Decreases the working speed.
Key T4
= Increases the working speed.
Key T5
= Intensive speed with timed stoppage. Suitable to deal with maximum
vapour
emission, this turns off automatically ten minutes after starting
operation. It can be disabled by pressing the key.
I N S T A L L A T I O N O F U N I T
(Read in conjunction with the following diagrams)
The unit is designed for 2.4 to 2.7 metre high ceiling.
Note: Ducting accessories are not supplied. The air outlet from the ducting flange
requires Ø150mm round ducting.
Before starting assembly, read the instructions carefully and remove the filters from
canopy to allow access to wall mounting holes. To remove the filters, push the
relative catch inward and tilting it downwards until it disengages from the supports.
Reverse these instructions when refitting the filters.
NOTE: Stainless steel is very easily damaged during installation if abraided or
knocked by tools.
WARNING
This hood has been designed to be wall-mounted above a cooking hob with the
back side resting against a wall. Because of the complexity and weight of the hood,
its installation should be carried out by qualified staff, taking care to respect all local
regulations on air discharge. The supplier cannot be found liable for any
damage due to improper installation.
This appliance is not intended for use by young children or infirm persons
without supervision.
Young children should be supervised to ensure that they do not play with
the appliance.
There shall be adequate ventilation of the room when the rangehood is
used at the same time as appliances burning gas or other fuels.
You must read the details concerning the method and frequency of
cleaning.
There is a fire risk if cleaning is not carried out in accordance with the
instructions.
Do not flambé under the rangehood.
Exhaust air must not be discharged into an existing flue which is used for
exhausting fumes from appliances burning gas or other fuels.
The minimum distance between the hob surface and the lowest part of the
rangehood is 600mm. This distance shall be at least 650mm (recom mended
700mm) if the rangehood is installed over a gas hob.
Attention should be given to ensure that any applicable regulations concerning
the discharge of exhaust air is fulfilled.
If the supply cord of this equipment is damaged, it must only be replaced by
the manufacturer or its service agent or similarly qualified person in order
to avoid a hazard.
W A R N I N G
F
C
T1
T2
T3
T4
T5
