7
•
According to the hanging board, drill 12 holes in the ceiling, see pic 2, 12pcs of ST6*40mm big flat screws
•
will be used to fix the hanging board on the ceiling, and then 8pcs of M4*10 screws and M4 nut with gasket
will be used to connect the angle iron into the hanging board, see pic 1, calculated the length of the angle
iron, and 16pcs M4*10 big flat screws and M4 nut with gasket will be used to connect the angle iron and
another angle iron ( the overlap length of angle iron cannot be less 100MM);
•
Let the one side of the expansion pipe go outside through the hole of 170MM, see pic 3.
•
4pcs ST4*8 big flat screws will be used to connect the inside chimney into the hanging board, then put on the
outside chimney, two hooks will be used to put up the outside chimney in order to the next installation, see
pic 4.
•
Hold up the hood, 16pcs M4*10 big flat screws will be used to connect the rangehood body into angle iron,
see pic 6.
•
Put the chimney on the outlet; ensure everything is OK;
•
Pull down the hook, slide down the outer flue, then the installation is completed, see pic7 & 8.
*If the wall or ceiling is not brick or concrete, an alternate mounting method must be determined.
Installation -
Continued
