9
Cleaning and maintenance
General Maintenance
Switch off the rangehood before cleaning or maintenance.
To prevent surface damage never use abrasive or oil based liquid cleaners. To clean the surfaces of the
appliance, use mild detergent and warm water. In areas of high humidity and coastal environments
cleaning should be carried out frequently.
Warning: Oil will build-up in the oil collector & must be emptied periodically.
External surfaces are susceptible to scratches and abrasions, so please follow the cleaning instructions to
ensure the best possible result is achieved without damage.
General
Cleaning and maintenance should be carried out with the appliance cold especially when cleaning. Avoid leaving
alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces.
Stainless Steel
The stainless steel must be cleaned regularly (e.g.weekly) to ensure long life expectancy. Dry with a clean soft
cloth. A specialized stainless steel cleaning fluid may be used.
Important: Ensure that wiping is done along with the grain of the stainless steel to prevent any unsightly
crisscross scratching patterns from appearing.
Control Panel Surface
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is clean and well wrung before
cleaning. Use a dry soft cloth to remove any excess moisture left after cleaning.
Important: Using neutral detergents and avoid using harsh cleaning chemicals, strong household detergents or
products containing abrasives, as this will affect the appliance appearance and potentially remove any printing of
artwork on the control panel and will void manufactures warrantee.
Aluminium Filters
The aluminum filters can be cleaned by hand. Soak them for about 3 minute in water with a grease-loosening
detergent then brush it gently with a soft brush. Please do not apply too much pressure to avoid damage. (Leave
to dry naturally out of direct sun light)
Filters should be washed separately to crockery and kitchen utensils. It is advised not to use rinse aid.
Replacement of LED Strip Lights
The LED strip lights cannot be replaced by the consumer. If any faults occur, please ring your nearest Service
Agent.
For any other problems please call help line on NZ 0800 760 667 or AUS 1800 648 556
