RR Series - ROYALE
APPROVED Page 6 of 8
ISSUE: F
ECN 3106
ROBINHOOD
B) TO REPLACE SWITCHES:
1
PULL CANOPY OPEN, REMOVE FILTERS AND UNFASTEN
SCREWS FIXING CONTROL PANEL TO BODY.SEE DIAGRAM
BELOW.
2
DROP CONTROL PANEL SLIGHTLY AND PULL FORWARD TO
DISENGAGE THE REAR TABS FROM THE BODY.
3
LIGHT & FAN SWITCH AND MICRO-SWITCH ARE LOCATED
INSIDE THE CONTROL PANEL.
4
REFER TO WIRING DIAGRAM FOR WIRING DETAILS.
5
REASSEMBLE RANGEHOOD IN REVERSE TO PROCEDURE
ABOVE, USING CABLE TIES ON WIRES WHERE NECESSARY.
B) TO REPLACE HEAT ALARM:
(Not applicable for units manufactured post June 2003 production.
1
PULL CANOPY OPEN, REMOVE FILTERS AND FAN BOX FRONT
COVER AS DESCRIBED IN SECTION A.
2
REMOVE HEAT ALARM COVER BY UNFASTENING THE
MOUNTING SCREW.
3
SQUEESE THE LOCKING BARBS OF THE PCB SUPPORT
THROUGH THE MOUNTING HOLES TO RELEASE THE HEAR
ALARM
4
REFER TO WIRING DIAGRAM FOR WIRING DETAILS.
5
REASSEMBLE RANGEHOOD IN REVERSE TO PROCEDURE
ABOVE, USING CABLE TIES ON WIRES WHERE NECESSARY.
6
TEST OPERATIONS OF HEAT ALARM - REFER TO HEAT ALARM
OPERATING INSTRUCTION.
