3
Pre-Installation
- continued
Ducting Options
The method of ducting should be carefully considered before installing the rangehood. The guide below
recommends the ducting components to use for all common ducting configurations - through the top of the home
(for the roof and soffit) and through the rear of the home. 150mm round ducting should be used in conjunction
with this model rangehood. Alternatively this rangehood can be operated in recirculation mode (see Recirculation
mode Pg.5).
It is recommended that Ø150mm ducting is to be used, however a reducer from Ø150mm to Ø120mm
is included with the rangehood should Ø120mm ducting be required.
Extra lengths and/or bends may be required, depending on the length required and whether there is any
structural material in the run e.g. rafters.
Some authorities require rangehoods to be vented outside. Ducted
models should comply with this requirement in
every respect.
Please note that this chart is designed as a guide. Please consult Robinhood customer services if unsure.
For NZ phone 0800 760 667 or www.robinhood.co.nz. For AUS phone 1800 648 556 or www.robinhood.com.au.
