4
Installation Instructions
•
Create a required cut‐out in the cabinet for your powerpack rangehood: 500x275mm for 52cm model,
730x275 for 75cm model 880x275mm for 90cm model. Refer to below picture. Make sure the cut‐out is at
least 35mm from the cabinet edge.
•
Put the hood into the cabinet, tighten up the screws by screwdriver, and make sure the hood was fixed. See
below picture.
•
Fix the expansion pipe on the outlet with cable tie. Note: the expansion pipe is not included in the product. See
below picture.
WARNING:
•
For safety reason, please use only the same size of fixing or mounting screws
which are recommended in this instruction manual.
•
Failure to install the screws or fixing device in accordance with these
instructions may result in electrical hazards.
