4
Cleaning
SAFETY PRECAUTION
Before cleaning your rangehood or performing any maintenance, please ensure that the rangehood is turned off at the
power point.
Do not use abrasive cleaners to clean the rangehood. The use of warm soapy water and a cloth are recommended.
Ensure that the rangehood is cleaned regularly, as a build‐up of grease and fat may occur otherwise.
The filters on the rangehood must be cleaned regularly to maintain efficiency, and prevent grease build up. The filter
mesh is made of a high density Stainless Steel. It is recommended that this is undertaken every 4 – 6 weeks, depending
on frequency of use. The filters can be cleaned with warm soapy water or a cloth.
Cleaning of the rangehood must be performed as described above; otherwise there is a possibility of a fire hazard due
to grease and fat build up.
Troubleshooting
Fault
Possible Cause
Solution
Light on, but motor
does not work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact Everdure Service.
Motor failed
Contact Everdure Service.
Light does not work,
motor does not work
House fuses blown
Reset/Replace fuses.
Power cord loose or disconnected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage
One‐way valve and the air ventilation
entrance are not tightly sealed
Take down the one‐way valve and seal with
sealant.
Leakage from the connection of U‐
shaped section and cover
Take U‐shaped section down and seal.
Lights not working
Broken/Faulty LED lamp
Contact Everdure Service.
Insufficient suction
The distance between the rangehood
and the gas top is too far
Refit the rangehood to the correct distance.
The Rangehood
inclines
The fixing screw not tight enough
Tighten the hanging screw and make it
horizontal.
