5
Installation
Mounting to a stud is recommended. However, if fitted to other wall linings (plasterboard, concrete etc) suitable fixings
will be required. Before drilling any holes check that the wall and ceiling are clear of any electrical cables, pipes etc.
1.
Pre drill pilot holes in the positions given. Fix the fixing plate using the screws supplied or appropriate wall
fixings, check with a spirit level to ensure bracket is level. Tighten screws.
2.
Mark the position of the decorative chimney at the ceiling and wall. Cut the cornice moulding away if required,
to enable the chimney to sit flush against the wall and ceiling.
3.
Only if ducting
‐ Mark and check, then cut out the hole in the ceiling / wall to fit the ducting (Ø160mm max).
4.
Using the screws supplied, fix the top chimney bracket to the wall, checking that is central about the canopy.
